Web Mountain Technologies RUC-01 Manual de usuario descargar pdf (Pagina 13)

Pick a COM port that will not commonly be used on your PC – we picked COM8 in this example. Use the

drop down and select COM8. In the IP address field, you have two options. If you are on the local LAN,

then you need to use the IP address of the RUC. As you can see above, this IP address will normally be a

non-routable address such as 192.168.x.xxx or 10.x.x.x. We highly recommend that you set the RUC to a

fixed address (rather than DHCP) if you are going to do this.

If you are going to access the RUC remotely as we started the discussion, then the IP address will be the

WAN IP address of the home. There are multiple ways to get this address – one way is to access the

website www.ipchicken.com and capture the address from there.

Next, enter the port # that you will use to access the remote network. By default, the RUC assigns port

9761 to COM1 on the RUC and port 9762 to COM2 on the RUC. These are configurable from the

Network Configuration page of the RUC, but there is rarely a reason to change them. Notice that we’ve

used 9762 as the port in this example, as it is the default port assigned to COM2. Now, any data routed

to port 9762 on the RUC will be switched internally to be sent out COM2.

If you are going to remotely access the RUC on port 9762 from your office, in order to make this work,

you must open a port through the local router’s firewall, in this case port 9762 to the local IP address of

the RUC.

1 2 ... 8 9 10 11 12 13 14 15

Sin comentarios

Web Mountain Technologies RUC-01 Manual de usuario Pagina 13