Web Mountain Technologies RUC-01 Manual de usuario

Using the Web Mountain RUC-01 with the ESI Drapery Control System Electronic Solutions, Inc, (ESI), is a manufacturer of an extremely powerful and f

The command !WBT>00; indicates that the motor is moving and started from a fully open position. Let’s say that we want some lights controlled by

Notice that you don’t need the leading ! or the trailing ;. The ESI command type takes care of this. Now, when you click on Add Trigger, the trigger

And, the trigger listing will look like this: While this demo was done with UPB, you could just as easily perform these same functions using Zwave o

Pick a COM port that will not commonly be used on your PC – we picked COM8 in this example. Use the drop down and select COM8. In the IP address fi

Now, click on the button in HW-VSP that says Create COM. You will see the status under VSP change to “Created” and Status under LAN change to Connect

For more information, please contact Web Mountain Technologies at 303-627-1856 or [email protected].

Now, the RUC-01 can be used to control the blinds by several methods (we call them Trigger Events):  Time of Day (including Sunset / Sunrise)  Upo

Notice that we are using the Command type in the Send Command area as RAW. This means that the RUC will not take care of any characters for you, mos

Get back to the Trigger Event screen. Here’s what the screen will look like to trigger on a UPB command of NID = 66, Link ID = 13 with a command of Ac

for much finer detail and control of individual motor controllers. Motor controllers are addressed randomly at the factory with an address that looks

RUC-01RQ BridgeRS-232COM2COM1Other protocol for Triggering, i.e., UPBRQBUSMotor Controller 1RQ60EYE AUXMTRRQBUSM50Q Enabled Blind / ShadeBlind / Drape

2. Setup COM2 on the Device Configuration page for the ESI settings, namely 9600-8-N-1. 3. Now, go to the Trigger Events page and let’s add some tri

And, we could do the same thing we did above with the RP command, use a UPB command or Zwave command to trigger sending the ESI RQ command. You might

!000v?; Request addresses and version numbers of all RQ elements !000r? Request the position of all the RQ60 controllers (blinds are open, closed